What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
09.06.2025 01:58

And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
The third is lightning and “how it gets conducted into a home.”
In schematic diagrams this is the symbol for a fuse:
This is the picture of an electronic coil of wire wound around a core of magnetic material.
2024–10–16 [ OO OLAOYE OYEBODE ]
This is 'the assistant's answer'
Wrongly deported Kilmar Abrego Garcia returning to U.S. to face criminal charges - Axios
Because the load is inductive, the current lags the voltage.(by a bit).
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
These devices are installed between the “hot” and “neutral” and protective ground.
Autism and ADHD have distinct brain connectivity signatures, study finds - Medical Xpress
This device then solves the entire problem.
It also is a device that limits the change in current flow.
He then describes Rainy Season and Lightning.
Nasa delays next flight of Boeing’s alternative to SpaceX Dragon - The Edge Malaysia
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
One
Is there a band whose members have been present for every one of their concerts?
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
This is where the MOV conducts again, and dissipated the energy.
the problem then depends on "how fast does the fuse operate?".
Now when you have a certain ac resistance, then a current flows in a loop.
The other is “what does a “fuse” do?”
One is “what exactly is in a ‘surge protector’ ? ”
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
There are two important concepts here.
Can you name an example of bad parenting?
[image of Common-mode choke]
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
This is where this question deviates from being a 'generic' question, and becomes more specific.
Latest AirPods Pro 2 feature is ahead of its time in the best way - 9to5Mac
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
What is lightning?
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
What caused the decline of the Soprano crew?
There are three different concepts here that are getting confused.
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
But… the neutral is now “floating” because of the 1 ohm resistance.
How can couples reverse the buildup of resentment once they notice it?
nine
But it can get overloaded, and no longer works.
These are simplified answers to the original question, and does not change anything I wrote above.
What are some tips for a girl with low self-esteem to start dating?
He then asserts :
It seems Mohan does not understand the difference between a comment and an Answer.
The MOV will conduct when the voltage exceeds 50% of line voltage.
iFixit is retroactively giving the Nintendo Switch a 4/10 on repairability - The Verge
For this case there are devices called Metal oxide varistors (MOV).
2024–10–10[John johnson John Johnson ]
but this device (an Inductor) … impedes the rapid changes in the current.
At one ohm, the resistor has a maximum of 1 watt power.
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
(Dc diagram shown, AC is similar).
eight
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
but I think this circuit , shows a few more pieces.
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
The bolt then partially travels down the line to your home.
a photo is worth a thousand words.
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
Upvotes:
First Sentence:
I post the exact comment here.
An AC voltage/ current source, and an ac inductive load.
so, what happens?
Here is a simplified AC power diagram.
Edit 2024–10.
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
what exactly is a ‘surge’ protector?
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
At least they know the answer if they wanted it.
Barnstars:
So, the voltage could go up to 500 volts, and the fuse will not open up.
He then describes the function of a fuse.
A circuit breaker is similar, but is resettable.
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
This one hit behind the barn.
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
Can the fuse protect the electronic devices from lightning instead of a surge protector.
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
A fuse is a non-resetable over current circuit protector.
[old diagram got deleted by accident]
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
What does a fuse do?
2024–10–14 [Omar Gharbi Omar Gharbi ]